Effect of Isothermal Heat Treatment at 650, 750 and 850°C on the Microstructures of Lean Duplex Stainless Steel S32101 Welds

Zbigniew Brytan* and Jerzy Niagaj
* Author for corresponding; e-mail address: zbigniew.brytan@polsl.pl
Volume: Vol.40 No.5 SPECIAL ISSUE 1
Research Article
DOI:
Received: -, Revised: -, Accepted: -, Published: -

Citation: Brytan Z. and Niagaj J., Effect of Isothermal Heat Treatment at 650, 750 and 850°C on the Microstructures of Lean Duplex Stainless Steel S32101 Welds, Chiang Mai Journal of Science, 2013; 40(5): 874-885.

Abstract

The presents paper deals with the influence of post welding heat treatment on the microstructure of particular zones in welded joints of the lean duplex stainless steel S32101. The joints were produced by a MAG welding method using single-pass technique. The welded joint were then treated by isothermal ageing. The phase composition of each welded joint was studied and the ferrite content in parent metal and in the heat affected zone (HAZ) was evaluated. Detailed microstructural analyses were made using both optical and scanning electron microscopy. The influence of isothermal heat treatment 650, 750 and 850°C on the microstructural changes and formation of precipitates in different zones of welded joints of the lean duplex stainless steel S32101 were studied. The stainless steel in the as-welded condition shows nitrides precipitation only in the HAZ. Isothermal heat treatment at 650°C for a short time (15min) causes the formation of numerous precipitates of nitrides at the grain boundaries and inside grains in each zone of the welded joints. The presence of inter-metallic σ-phase was not revealed in either parent metal or welded joint even after heat treatment at 850°C for 90 min.

Keywords: lean duplex stainless steel, Mag welded joint, microstructure, isothermal heat treatment

Phase formations, Compressive Strength and Microstructure of Environmentally Friendly Thai Lopburi Calcined Clay-Limestone Cement Mixes
DOI: 10.12982/CMJS.2024.089.

Arnon Chaipanich, Nalintip Sansuthum, Phakin Chomyen, Kornnika Wianglor and Supakporn Aodkeng

Vol.51 No.6 (November 2024)
Research Article View: 1,454 Download: 325

The Effect of Double Solution Treatment on Changes in the Microstructure of Austenitic Manganese Steel
DOI: 10.12982/CMJS.2023.060.

Arif Tjahjono, Nadya Salsabila Frendyta and Permana Andi Paristiawan

Vol.50 No.6 (November 2023)
Research Article View: 1,065 Download: 549

Microstructure, Tensile, and Fractography Analysis of Al2016 and Al2618 Age Hardened Aluminium Alloys
DOI: 10.12982/CMJS.2022.066.

Arivumani Ravanan, Ilamathi Palanivel and Balamurugan Kulendran

Vol.49 No.4 (July 2022)
Research Article View: 1,756 Download: 873

Deconvolution of Microstructural Distributions of Ethylene/1- Butene Copolymer Blends using Artificial Neural Network
DOI: 10.12982/CMJS.2022.019.

Piriyakorn Piriyakulkit and Siripon Anantawaraskul

Vol.49 No.1 (Special Issue I : Jan 2022)
Research Article View: 1,493 Download: 511

Influence of Deep Cryogenic Treatment on Microstructure, Hardness, Impact Strength and Wear of CuBeZr Alloy
page: 631 - 647

Nuwan Wannaprawat and Karuna Tuchinda

Vol.48 No.2 (March 2021)
Research Article View: 1,055 Download: 532

Fabrication of Open-cell Aluminum Foams by Pressure Infiltration and Salt Leaching Method from Commercial Grade Alloys
page: 673 - 685

Pat Sooksaen* and Pathompong Puathawee

Vol.47 No.4 (Special Issue II : July 2020)
Research Article View: 1,031 Download: 1,092

Oxide Inclusions in Austenitic/Lean Duplex Stainless Steels Joined by Flux-cored Arc Welding
page: 329 - 342

Suphitcha Moonngam, Pranpreeya Wangjina, Ekkarut Viyanit, Namurata Sathirachinda Palsson and Chaiyasit Banjongprasert

Vol.47 No.2 (Special Issue I : March 2020)
Research Article View: 1,013 Download: 736

Physical Properties and Microstructure of a Fe-Ni-Co Alloy Prepared by Sintering Metal Powders Under Nitrogen Gas Atmosphere
page: 17 - 25

Sirisak Seansukato and Torranin Chairuangsri*

Vol.31 No.1 (JANUARY 2004)
Research Article View: 884 Download: 286

Influence of Calcium Salts on Quality and Microstructure of Minimally-processed Litchi Fruit
page: 46 - 61

Putkrong Phanumong, Sang Moo Kim, Jurmkwan Sangsuwan, Noppol Leksawasdi and Nithiya Rattanapanone

Vol.46 No.1 (January 2019)
Research Article View: 938 Download: 424

Effects of Cobalt Dopant on Microstructure and Electrical Properties of Bi0.5Na0.5TiO3 Ceramics
page: 2481 - 2490

Suwapitcha Buntham, Paitoon Boonsong, Panupong Jaiban, Nittaya Keawprak and Anucha Watcharapasorn

Vol.45 No.6 (September 2018)
Research Article View: 930 Download: 347

Microstructure and Wear Behavior of Hardfacing with Ferro-alloy Powder Addition Using Submerged Arc Welding
page: 2034 - 2047

Buntoeng Srikarun and Prapas Muangjunburee*

Vol.45 No.5 (Special 2018)
Research Article View: 990 Download: 528

Fabrication of Porous Ceramics from Non-metallic Residue Obtained from Aluminum Recycling Plant
page: 1099 - 1110

Pat Sooksaen* and Pathompong Puathawee

Vol.45 No.2 (March 2018)
Research Article View: 1,017 Download: 331

Characteristics and Flavor Retention of Structured Emulsion from Pomelo (Citrus maxima) Residue
page: 949 - 960

Yot Boontongkong, Jaruwan Yaemsiri and Pawadee Methacanon*

Vol.45 No.2 (March 2018)
Research Article View: 1,007 Download: 426

Effect of Heat Treatment on High Temperature Damping Capacity of ZK60 Sheet Produced by Twin-roll Casting and hot-rolling
page: 351 - 357

Chen Hongmei* [a], Liu Zhongming [a], Zang Qianhao [a, b], Yu Xin [a], Zhang Jing [c] and Jin Yunxue [a]

Vol.43 No.2 (SPECIAL ISSUE 1)
Research Article View: 912 Download: 285

Microstructure and Mechanical Properties of As-cast and Heat-treated 935AgCuBeSn Alloys
page: 206 - 214

Siriwan Sakultanchareonchai [a], Torranin Chairuangsri [b] and Ekasit Nisaratanaporn*[a]

Vol.43 No.1 (JANUARY 2016)
Research Article View: 953 Download: 461

Microstructural Characterization of Lean Duplex Stainless Steel UNS S32101 Welded Joints Using Electron Backscatter Diffraction
page: 923 - 937

Zbigniew Brytan* and Jerzy Niagaj

Vol.40 No.5 SPECIAL ISSUE 1
Research Article View: 854 Download: 284

Characteristics of Microstructure, Microhardness, and Oxidation of FSW and MIG Welded Steels
page: 831 - 838

Seul Ki Kim, Seung Boo Jung and Dong Bok Lee*

Vol.40 No.5 SPECIAL ISSUE 1
Research Article View: 896 Download: 290

Microstructures in Pyrope Garnets from Thailand
page: 669 - 677

Bongkot Phichaikamjornwut, Henrik Skogby, Prayote Ounchanum, Phisit Limtrakun and Apichet Boonsoong

Vol.39 No.4 (OCTOBER 2012)
Research Article View: 843 Download: 317

Effect of carburizing via current heating technique on the near-surface microstructure of AISI 1020 steel
page: 254 - 262

Chatdanai Boonruang*a, Wareelak Kumpangkeawa, Kittichai Sopunnab, Natthaphol Chomsaengc, Suparut Nar

Vol.39 No.2 (APRIL 2012)
Research Article View: 991 Download: 258

Isothermal Phase Transformation Sequence in Fe-22wt%Cr-3.2wt%Mo-6.2wt%Ni-0.037wt%C Cast Duplex Stainless Steel
page: 47 - 55

Surasak Kuimalee*[a], John T.H. Pearce [b] and Torranin Chairuangsri**[c]

Vol.38 No.1 (JANUARY 2011)
Research Article View: 883 Download: 259

Effects of Al2O3 Nano-Particulates Addition on Barium Titanate Ceramics
page: 175 - 182

Sukanda Jiansirisomboon*, Anucha Watcharapasorn and Tawee Tunkasiri

Vol.33 No.2 (MAY 2006)
Research Article View: 968 Download: 232

Microstructures and Mechanical Properties of Zirconium-Doped Bismuth Sodium Titanate Ceramics
page: 169 - 173

Anucha Watcharapasorn*, Sukanda Jiansirisomboon and Tawee Tunkasiri

Vol.33 No.2 (MAY 2006)
Research Article View: 935 Download: 226

A Novel Method to Produce Silver Foams with Multilevel Porosities
page: 296 - 301

Seksak Asavavisithchai, Ekasit Nisaratanaporn, and Yuttanant Boonyongmaneerat

Vol.36 No.3 (SEPTEMBER 2009)
Research Article View: 953 Download: 238

Effects of Beryllium on Microstructure and Resiliency of Silver-Copper Alloy
page: 260 - 268

Torranin Chairuangsri, and Ekasit Nisaratanaporn

Vol.37 No.2 (MAY 2010)
Research Article View: 986 Download: 293

Chiang Mai Journal of Science

1,647

Q3 0.80

Q3 1.3

7 days

Outline

Figures and Tables